How to remove and replace the Serpentine belt

Serpentine belt and Tensioner for the Ford Explorer all models?

What is a Serpentine belt?
The term "serpentine" refers to the belt style of which there are typically three: "V" belt, multi-grooved serpentine, and flat.

Where do you find the Serpentine Diagram?
The diagram should be under the hood in front of radiator.

How are Serpentine belts adjusted?
Most serpentine belts use a spring-loaded self-adjusting tensioner; these tensioners have a spot for a breaker bar or ratchet wrench (some use a socket & some don't) that turn either clockwise or counterclockwise to loosen and/or tighten.

How do you remove and replace the Serpentine belt
I recommend two people for this job, one on top the other underneath. This will make it go quicker.

1. Find the tensioner that is holding pressure on the belt. You must remove this tension in order to remove the belt. Some tensioner's have a slot for a ratchet to be inserted to allow you to remove the pressure. Some have a pry point.

2: Turn the ratchet clockwise until enough tension is relieved to move the belt off of the belt tensioner.

3: Ford recommends replacing the belt tensioner every 100,000 miles.

4: After removing the serpentine belt check the back of the belt and smooth side pulleys for glazing. If these seem extremely glazed use a 400 grit wet dry sand paper to deglaze the surface (these surfaces rely on tension to turn them properly, if they are excessively slick they may slip)

5: Using the diagram on the top of the radiator replace the belt.

Total time should be 5-10 minutes if you take your time.

Answer

Your local auto parts store, auto zone, etc. they should be able to pull it up on their computers and print you a copy for free.


	Buy Brand Name Replacement & Performance Parts Search by make:
	Powered by Auto Parts Warehouse